power-adhesive

MultiFix Power Adhesive is a new generation, fast curing, 2-part structural adhesive that will bond just about any material to any material including metals, most plastics, glass, fibreglass, wood, composites, carbon fibre, brick, concrete, stone, gems, and much more. It is not suitable for Polypropylene, Polyethylene or PTFE.

This toughened acrylic adhesive offers many benefits over standard epoxy adhesives. MultiFix Power Adhesive does not require mixing, it can be applied direct from the cartridge ‘bead on bead’. It is also non odour and non flammable which means it is safe to use in just about any environment and will not carry a lingering odour.

Typically MultiFix Power Adhesive will cure to rough handling strength in approximately 3 to 5 minutes at room temperature and will fully cure in just 1 hour. It is available in our unique 12ml cartridge.

Directions for use: Lightly abrade parts to be bonded. Ensure the parts are, dry, clean and free from dirt, oil or grease. Push down red cap firmly on a hard surface to break the cartridge skins. Remove red cap and depress plunger gently with thumb to ensure both components flow freely and equally. Clean cartridge tip with tissue and then apply adhesive ensuring the two adhesive beads flow ‘one on top of the other’ and press or clamp the two parts to be bonded together for 5 minutes. Clean away any excess. For transparent bond lines mix the adhesive for 20 seconds and apply to one surface. Clamp or press firmly together for 5 minutes in order for the adhesive to reach rough handling strength. Full cure is achieved in one hour.